York LEU360 Manuel d'utilisateur Page 1

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Ventilateurs et séchoirs à air York LEU360. Tech Guide H2CA300 [en] Manuel d'utilisatio

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 12
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 0
GENERAL
These units are designed for outdoor installation on a roof or
at ground level. Every unit is completely packaged, piped and
wired at the factory. Each unit is dehydrated, evacuated, leak
tested and pressure tested at 450 psig before being pressurized
with a holding charge of refrigerant-22.
All controls are located in the front of the unit and are readily
accessible for maintenance, adjustment and service. All wiring
(power and control) can be made through the bottom of the unit.
REFERENCE
This instruction covers the installation and operation of the
basic condensing unit and interconnecting refrigerant mains.
For information on the installation of the matching evaporator
blower unit, refer to the following instruction:
Model LEU360 - Form 550.13-N8
Additional information on the design, installation, operation and
service of this equipment is available in the following reference
forms.
55.70-N1 - General Installation
55.70-N2 - Pre-start & Post-start Check List
55.70-N3 - General Service Information
55.05-NM - Evacuation and Charging
Renewal Parts:
Refer to Parts Manual for complete listing of replacement
parts on this equipment.
The above forms and all other forms referenced in this instruc-
tion may be ordered from:
Publications Distribution Center
Unitary Products Group
P.O. Box 1592, York, Pa. 17405
INSPECTION
As soon as a unit is received, it should be inspected for possible
damage during transit. If damage is evident, the extent of the
damage should be noted on the carrier’s freight bill. A separate
request for inspection by the carrier’s agent should be made in
writing. See Form 50.15-NM for additional information.
AIR COOLED
SPLIT-SYSTEM AIR CONDITIONERS
INSTALLATION INSTRUCTION
Supersedes: 550.13-N3Y (692)
550.13-N3Y (897)
Installer should pay particular attention to the words:
NOTE, CAUTION
and
WARNING
. Notes are intended to clarify or make
the installation easier. Cautions are given to prevent equipment damage. Warnings are given to alert installer that personal in-
jury and/or equipment damage may result if installation procedure is not handled properly.
MODELS H2CA300 & 360
Style D
035-14873
®
CAUTION
THIS PRODUCT MUST BE INSTALLED IN STRICT COMPLIANCE
WITH THE ENCLOSED INSTALLATION INSTRUCTIONS AND ANY
APPLICABLE LOCAL, STATE, AND NATIONAL CODES
INCLUDING, BUT NOT LIMITED TO, BUILDING, ELECTRICAL,
AND MECHANICAL CODES.
WARNING
INCORRECT INSTALLATION, ADJUSTMENT, ALTERATION,
SERVICE OR MAINTENANCE CAN CAUSE INJURY OR
PROPERTY DAMAGE. REFER TO THIS MANUAL.FOR
ASSISTANCE OR ADDITIONAL INFORMATION, CONSULT A
QUALIFIED INSTALLER OR SERVICE AGENCY.
Vue de la page 0
1 2 3 4 5 6 ... 11 12

Résumé du contenu

Page 1 - INSTALLATION INSTRUCTION

GENERALThese units are designed for outdoor installation on a roof orat ground level. Every unit is completely packaged, piped andwired at the factory

Page 2 - TABLE OF CONTENTS

AIROUT1-1/41"OVERHANGHOLE WITH GROMMET FOR2-1/8 OD SUCTION LINE56-3/47/8" HOLE WITH GROMMETFOR 24-VOLT CONTROL WIRING7/8" HOLE FOR 115-

Page 3 - INSTALLATION

CAUTION: Never operate the compressor while under a deepvacuum.NOTE: The timing intervals described in the following proce-dures are nominal. Some var

Page 4 - USE SPREADER BARS

Caution: Repeated reset of the lockout circuit and/or oil pres-sure control may cause damage to the unit!NOTE: The compressor module is not in the loc

Page 5 - TABLE 4 - ELECTRICAL DATA

General ... 1Reference ...

Page 6 - 6 Unitary Products Group

LIMITATIONSThese units must be installed in accordance with all nationaland local safety codes. If no local codes apply, installation mustconform with

Page 7 - Unitary Products Group 7

locking devices on the panels may be advisable. Check localauthorities for safety regulations.CLEARANCESThe units must be installed with sufficient cl

Page 8 - TABLE 5 - SUCTION LINES

If the main switch is disconnected for long periods of shut down,do not attempt to start the unit for 8 hours after the switch hasbeen re-connected. T

Page 9 - REFRIGERANT-22 LINE CHARGE

The stop valve in the liquid line ahead of the filter-drier and thesuction valve permit replacing the expansion valve or the drierwithout loss of refr

Page 10 - UNIT DIMENSIONS

COND.SECTIONL1L2 L312NRBX1Y1 Y2TB1TO LOCKOUTALARMTB3TB2POWER SUPPLY 208/230,460 OR 575-3-60DISCONNECT SWITCHESAND FUSING BY FIELDLIQUID LINESOLENOID V

Page 11 - OPERATION

ModelDesignationNominalCapacity(Tons)RefrigerantFlow Rate4(Lbs./Min.)Type LCopper Tubing(Inches,O.D.)RefrigerantGasVelocity(Ft./Min.)FrictionLoss5,6(P

Page 12 - SECURE OWNER’S APPROVAL:

ModelDesignationNominalCapacity(Tons)RefrigerantFlow Rate1(Lbs./Min.)Type LCopper Tubing(Inches, O.D.)Pressure Drop3Friction2(PSI/100 Ft.)VerticalRise

Commentaires sur ces manuels

Pas de commentaire