York ZJ Series Spécifications télécharger pdf (Page 5)

527730-YIM-D-0310

Johnson Controls Unitary Products 5

Installation

Installation Safety Information

Read these instructions before continuing this appliance

installation. This is an outdoor combination heating and cooling

unit. The installer must assure that these instructions are made

available to the consumer and with instructions to retain them

for future reference.

1. Refer to the unit rating plate for the approved type of gas

for this product.

2. Install this unit only in a location and position as specified

on Page 7 of these instructions.

3. Never test for gas leaks with an open flame. Use

commercially available soap solution made specifically for

the detection of leaks when checking all connections, as

specified on Pages 5, 29, 30 and 48 of these instructions.

4. Always install furnace to operate within the furnace's

intended temperature-rise range with the duct system and

within the allowable external static pressure range, as

specified on the unit name/rating plate, specified on

Page 50 of these instructions.

5. This equipment is not to be used for temporary heating of

buildings or structures under construction.

Preceding Installation

1. Remove the two screws holding the brackets in the front,

rear and compressor side fork-lift slots.

Figure 1: Unit Shipping Bracket

2. Turn each bracket toward the ground and the protective

plywood covering will drop to the ground.

3. Remove the condenser coil external protective covering

prior to operation.

4. Remove the toolless doorknobs and instruction packet

prior to installation.

Figure 2: Condenser Covering

Figure 3: Compressor Section

5. If a factory option convenience outlet is installed, the

weatherproof outlet cover must be field installed. The cover

shall be located behind the filter access panel. To install

the cover, remove the shipping label covering the

convenience outlet, follow the instructions on the back of

the weatherproof cover box, and attach the cover to the

unit using the (4) screws provided.

FIRE OR EXPLOSION HAZARD

Failure to follow the safety warning exactly could result

in serious injury, death or property damage.

Never test for gas leaks with an open flame. use a

commercially available soap solution made specifically

for the detection of leaks to check all connections. A fire

or explosion may result causing property damage,

personal injury or loss of life.

Bracket

Screws

Turn down

208/230-3-60 and 380/415-3-50 units with factory

installed Powered Convenience Outlet Option are wired

for 230v and 415v power supply respectively. Change

tap on transformer for 208-3-60 or 380-3-50 operation.

See unit wiring diagram.

Condenser

Coil External

Protective

Covering

Barometric

Relief Hood

in Shipping

Location

(if Included)

Toolless

Doorknobs

Installation

Instruction

Packet

1 2 3 4 5 6 7 8 9 10 ... 54 55

Commentaires sur ces manuels

Pas de commentaire

York ZJ Series Spécifications Page 5

Commentaires sur ces manuels

Produits connexes et manuels pour Pompes à chaleur York ZJ Series